Licensed & insured Certified Arborist on staff Serving DFW since 2014

Stump Grinding & Stump Removal in Cleburne, Texas

Grinding stumps 6–12 inches below grade so the ground can be re-used. Serving Cleburne and the rest of Johnson County since 2014 — free written estimates, fully insured crews, and complete clean-up.

Call (817) 508-9940 Get a free estimate

Do you provide stump grinding in Cleburne, TX?

Stump Grinding & Stump Removal in Cleburne, Texas. Grinding stumps 6–12 inches below grade so the ground can be re-used. Most Cleburne jobs fall between $95 and $600. Tree Service Pros has worked Johnson County since 2014. Free written estimate, full clean-up included, and no work starts without your sign-off.

We have been doing stump grinding work in and around Cleburne since 2014. A stump left in the ground is a trip hazard, a mower-killer and a termite and Ganoderma host. Grinding is far cheaper than excavating the root plate.

Root plates here are wide and shallow because there is nowhere to go down — limestone is often less than two feet under the grass. That matters for grinding: in Cleburne the roots run wide and shallow rather than deep, so surface roots often need taking down along with the stump.

Service
Stump Grinding
Area
CleburneJohnson County
Typical range
$95–$600per job, varies by site
Estimates
Freewritten, no obligation

What is included in Cleburne

  • Ground 6–12 in. below grade for replanting or sod
  • Surface-root grinding along walks and drives
  • Chip backfill or full haul-off — your call
  • Narrow-access machines for gated back yards
  • Utility locate before every grind

Grinding versus digging a stump out

Grinding uses a carbide wheel to chew the stump into mulch, typically six to twelve inches below grade — deep enough to plant grass over, and deep enough for most replanting if you cut a fresh hole beside it rather than in it. Excavating the whole root plate with a machine costs several times as much, wrecks the surrounding lawn, and is only necessary if you are pouring a foundation or a pool over the spot.

The by-product is a surprising amount of chip. A stump grinds into roughly twice the volume of the stump itself, mounded over the hole. You can leave it as backfill — it settles over a season — or we haul it and bring in topsoil. Decide before we start; it changes the price.

Always locate before grinding

Stump grinders cut below grade, and irrigation lines, low-voltage lighting, gas service and cable drops all live at exactly that depth. Every grind we do starts with an 811 locate for public utilities, and we ask you to flag private lines — sprinkler heads and landscape lighting are not on the locate.

How the job runs

Stump Grinding in Cleburne, step by step

  1. Confirm depth and finish

    Replanting, sod, or just level? That sets how deep we go.

  2. Locate utilities

    811 ticket for public lines; you flag sprinklers and lighting.

  3. Protect the surrounds

    Screens and mats — grinding throws chip and the occasional stone a long way.

  4. Grind past the flare

    Down to depth and out to the buttress roots, not just the visible stump.

  5. Backfill or haul

    Chip raked back in and topped off, or removed and replaced with topsoil ready for seed.

Pricing

What stump grinding costs in Cleburne

Most stump grinding work in Cleburne falls between $95 and $600 for a typical residential job. That is a real range, not a teaser — what puts a job at one end or the other is below.

What moves the price

  • Stump diameter measured at the widest point of the flare, not the cut face
  • Grinding depth — replanting depth costs more than level-with-grade
  • Access; a walk-behind grinder through a narrow gate is slower
  • Whether chip is backfilled or hauled off and replaced with soil
  • Rock or embedded metal — old fence line stumps are frequently full of wire

The only way to get a real number is for someone to look at it. That visit is free — request an estimate or call (817) 508-9940. Full pricing detail for every service is in our North Texas tree service cost guide.

Local conditions

Cleburne soil, species and timing

Cleburne sits on thin, rocky alkaline clay over limestone bedrock — Fort Worth Prairie ground. That drives what grows well here (live oak, cedar elm and Texas ash dominate the older streets) and what goes wrong: iron chlorosis is the condition we are called out for most.

We cover ZIP codes 76031 and 76033. We are regularly within a few minutes of Cleburne: Keene (4 mi), Coyote Flats (7 mi), Joshua (7 mi) and Rio Vista (8 mi) are all on the same route.

People in Cleburne search for this as stump grinder, stump removal service, or simply stump removal in Cleburne — it is all the same job, and the estimate is free either way.

FAQ

Stump Grinding in Cleburne — questions we get asked

Can I plant a new tree where the old stump was in Cleburne?

Not directly in the same hole. Even ground to twelve inches, the remaining root mass decays for years, robs nitrogen as it does, and leaves a void that settles. Plant three to four feet to the side, or grind deep and excavate the chip out and replace with topsoil if the location matters.

Do you remove the roots as well as the stump?

Grinding takes the stump and the surface roots radiating from it. It does not chase lateral roots across the yard — those decay in place over several years and are rarely a problem. If you are building over the spot, tell us and we will price full root-plate excavation instead.

Are you licensed and insured to work in Cleburne?

We carry general liability and workers' compensation, and we will send the certificate before you book — not after. Texas does not license tree services at state level, which is exactly why the insurance question matters: if an uninsured crew damages your property or injures someone on it, that lands on your homeowner's policy.

What happens if it rains on my scheduled day?

We reschedule. Saturated ground means ruts and, more importantly, compromised anchor points and footing — nobody should be aloft in a tree in a North Texas thunderstorm. You get a call, not a no-show.

Will you damage my lawn or sprinkler system?

We plate or mat soft ground before anything heavy crosses it, and we ask you to flag sprinkler heads and low-voltage lighting, which do not show up on a utility locate. Some rutting is possible on saturated ground — if it happens, repairing it is on us.

How soon can you get to my property in Cleburne?

Estimates in Cleburne are usually within a couple of business days. Scheduled work typically runs one to two weeks out depending on season — spring and post-storm periods are busiest. Hazard situations get moved to the front of the queue.

Do you serve areas outside Cleburne?

Yes — our regular territory covers Tarrant, Johnson, Parker, Hill and Bosque Counties and the cities inside them. Cleburne is on our normal route.

Can you work around my schedule?

Usually. Most residential work happens on weekdays during business hours, but we can often arrange early starts or a specific day if access, pets or gates require it. Commercial properties routinely get after-hours or weekend scheduling.

Stump Grinding near Cleburne

We cover the whole corridor, so a job in Cleburne is rarely a special trip.

See all cities in Johnson County, or our full service area map. Looking for stump grinding across the whole region? See Stump Grinding & Stump Removal.

Need stump grinding in Cleburne?

Free written estimate, usually within a couple of business days. Licensed, insured, and we clean up completely.

(817) 508-9940

Request a free estimate

Monday–Friday, 8:00 AM – 5:00 PM · Storm and hazard calls are answered outside office hours.

Call (817) 508-9940