Licensed & insured Certified Arborist on staff Serving DFW since 2014

Tree Cabling & Bracing

Hardware support for split unions and heavy limbs worth keeping. Serving Tarrant, Johnson, Parker, Hill and Bosque Counties from south Fort Worth since 2014.

Call (817) 508-9940 Free estimate

What is cabling and bracing?

A cable buys a structurally-flawed tree years it would not otherwise get. It is almost always cheaper than removing and replacing a mature shade tree. Tree Service Pros provides cabling and bracing across North Central Texas — free written estimates, insured crews, complete clean-up. Call (817) 508-9940.

A cable buys a structurally-flawed tree years it would not otherwise get. It is almost always cheaper than removing and replacing a mature shade tree.

When you need it: A big tree with a crack or a weak fork.

Service
Cabling & Bracing
Typical range
$350–$1,600varies by site
Estimates
Freewritten
Counties
5Tarrant · Johnson · Parker · Hill · Bosque

What is included

  • Co-dominant stem cabling
  • Threaded rod bracing through split unions
  • ANSI A300 Part 3 installation
  • Annual hardware inspection
  • Used to save heritage and specimen trees

When hardware is the right answer

Cabling and bracing supports a structural defect that cannot be pruned away — most often a co-dominant union with included bark on a tree too valuable to lose. A cable installed high in the canopy limits how far the two stems can move apart in wind; a brace rod goes through the union itself and resists the split directly.

It is not permanent and it is not maintenance-free. Hardware needs inspecting annually and the tree keeps growing around it. What it buys is time — often decades — on a tree whose replacement cost and shade value dwarf the installation.

Hardware does not fix a hollow tree

Cabling supports a union. It does nothing for advanced internal decay, root-plate failure or a compromised trunk, and installing it on a tree with those problems creates false confidence about something that is still going to come down. The assessment comes before the hardware.

How it works

Our cabling & bracing process

  1. Assess the defect

    Union geometry, included bark, existing cracks, and the decay picture in the trunk below.

  2. Decide if it is worth supporting

    Some trees should be reduced or removed instead. We will say so.

  3. Install to ANSI A300 Part 3

    Correct height, correct hardware, drilled and through-bolted rather than wrapped.

  4. Reduce the load

    Cabling usually pairs with crown reduction to cut the leverage on the union.

  5. Inspect annually

    Hardware and union checked every year; cables adjusted as the tree grows.

Pricing

What cabling and bracing costs in North Texas

What moves the price

  • Number of cables and whether bracing rods are also required
  • Canopy height and access for installation
  • Whether crown reduction is done at the same time
  • Tree species and wood strength
  • Annual inspection agreement

See the full cost guide for every service, or request a free written estimate.

FAQ

Cabling & Bracing — frequently asked

Do you clean up afterwards?

Completely. Brush chipped and hauled, wood removed or stacked as you prefer, ground raked and blown off. We walk the site with you before we leave. Clean-up is included in the quoted price — it is not a line item that appears later.

Do you give free estimates in North Texas?

Yes. Someone comes out, looks at the tree, and you get a written price with the scope spelled out — no charge and no obligation. We do not quote tree work over the phone from a description, because the things that change the price (access, what is underneath, how the wood has to come out) are not visible from a description.

Do you offer discounts for multiple trees?

Effectively yes — the second tree on the same visit costs less than it would on its own because setup, travel and haul-off are already covered. If you have several trees needing attention, get them all quoted at once rather than one at a time.

What payment methods do you take?

All standard forms — card, check, cash and bank transfer. On larger jobs a deposit is normal with the balance due on completion, after you have seen the finished work. We do not ask for payment in full before starting.

Are you licensed and insured to work in North Texas?

We carry general liability and workers' compensation, and we will send the certificate before you book — not after. Texas does not license tree services at state level, which is exactly why the insurance question matters: if an uninsured crew damages your property or injures someone on it, that lands on your homeowner's policy.

What happens if it rains on my scheduled day?

We reschedule. Saturated ground means ruts and, more importantly, compromised anchor points and footing — nobody should be aloft in a tree in a North Texas thunderstorm. You get a call, not a no-show.

Will you damage my lawn or sprinkler system?

We plate or mat soft ground before anything heavy crosses it, and we ask you to flag sprinkler heads and low-voltage lighting, which do not show up on a utility locate. Some rutting is possible on saturated ground — if it happens, repairing it is on us.

How soon can you get to my property in North Texas?

Estimates in North Texas are usually within a couple of business days. Scheduled work typically runs one to two weeks out depending on season — spring and post-storm periods are busiest. Hazard situations get moved to the front of the queue.

Get a free cabling & bracing estimate

Written price, clear scope, insured crew. No obligation to book.

(817) 508-9940

Request a free estimate

Monday–Friday, 8:00 AM – 5:00 PM · Storm and hazard calls are answered outside office hours.

Call (817) 508-9940