Licensed & insured Certified Arborist on staff Serving DFW since 2014

Stump Grinding & Stump Removal in Hubbard, Texas

Grinding stumps 6–12 inches below grade so the ground can be re-used. Serving Hubbard and the rest of Hill County since 2014 — free written estimates, fully insured crews, and complete clean-up.

Call (817) 508-9940 Get a free estimate

Do you provide stump grinding in Hubbard, TX?

Yes — we do stump grinding throughout Hubbard, TX. Grinding stumps 6–12 inches below grade so the ground can be re-used. Most Hubbard jobs fall between $95 and $600. We are a licensed, insured Hill County tree service with a Certified Arborist on staff, and estimates cost nothing.

Hubbard is a small Hill County town of roughly 1,394 — bigger lots, older trees, and fewer crews willing to drive out. A stump left in the ground is a trip hazard, a mower-killer and a termite and Ganoderma host. Grinding is far cheaper than excavating the root plate.

Drainage is the recurring problem — water sits, roots suffocate, and Phytophthora gets into a root collar that never dries. That matters for grinding: in Hubbard the roots run wide and shallow rather than deep, so surface roots often need taking down along with the stump.

Service
Stump Grinding
Area
HubbardHill County
Typical range
$95–$600per job, varies by site
Estimates
Freewritten, no obligation

What is included in Hubbard

  • Ground 6–12 in. below grade for replanting or sod
  • Surface-root grinding along walks and drives
  • Chip backfill or full haul-off — your call
  • Narrow-access machines for gated back yards
  • Utility locate before every grind

Grinding versus digging a stump out

Grinding uses a carbide wheel to chew the stump into mulch, typically six to twelve inches below grade — deep enough to plant grass over, and deep enough for most replanting if you cut a fresh hole beside it rather than in it. Excavating the whole root plate with a machine costs several times as much, wrecks the surrounding lawn, and is only necessary if you are pouring a foundation or a pool over the spot.

Pricing

What stump grinding costs in Hubbard

Most stump grinding work in Hubbard falls between $95 and $600 for a typical residential job. That is a real range, not a teaser — what puts a job at one end or the other is below.

What moves the price

  • Stump diameter measured at the widest point of the flare, not the cut face
  • Grinding depth — replanting depth costs more than level-with-grade
  • Access; a walk-behind grinder through a narrow gate is slower
  • Whether chip is backfilled or hauled off and replaced with soil
  • Rock or embedded metal — old fence line stumps are frequently full of wire

The only way to get a real number is for someone to look at it. That visit is free — request an estimate or call (817) 508-9940. Full pricing detail for every service is in our North Texas tree service cost guide.

Local conditions

Hubbard soil, species and timing

Tree work in Hubbard is shaped by the soil more than anything else. Drainage is the recurring problem — water sits, roots suffocate, and Phytophthora gets into a root collar that never dries. The species that handle it — bur oak, cedar elm, pecan — are the ones you see on every mature street, and shrink-swell root damage is their recurring problem.

We cover ZIP code 76648. Hubbard sits inside a tight cluster of towns we run every week: Malone (7 mi), Penelope (8 mi), Mount Calm (8 mi) and Irene (11 mi) are all on the same route.

People in Hubbard search for this as tree stump removal, stump removal service, or simply stump grinding service in Hubbard — it is all the same job, and the estimate is free either way.

FAQ

Stump Grinding in Hubbard — questions we get asked

Can I plant a new tree where the old stump was in Hubbard?

Not directly in the same hole. Even ground to twelve inches, the remaining root mass decays for years, robs nitrogen as it does, and leaves a void that settles. Plant three to four feet to the side, or grind deep and excavate the chip out and replace with topsoil if the location matters.

Do you remove the roots as well as the stump?

Grinding takes the stump and the surface roots radiating from it. It does not chase lateral roots across the yard — those decay in place over several years and are rarely a problem. If you are building over the spot, tell us and we will price full root-plate excavation instead.

Do you offer discounts for multiple trees?

Effectively yes — the second tree on the same visit costs less than it would on its own because setup, travel and haul-off are already covered. If you have several trees needing attention, get them all quoted at once rather than one at a time.

Can you work around my schedule?

Usually. Most residential work happens on weekdays during business hours, but we can often arrange early starts or a specific day if access, pets or gates require it. Commercial properties routinely get after-hours or weekend scheduling.

Will you damage my lawn or sprinkler system?

We plate or mat soft ground before anything heavy crosses it, and we ask you to flag sprinkler heads and low-voltage lighting, which do not show up on a utility locate. Some rutting is possible on saturated ground — if it happens, repairing it is on us.

Stump Grinding near Hubbard

We cover the whole corridor, so a job in Hubbard is rarely a special trip.

See all cities in Hill County, or our full service area map. Looking for stump grinding across the whole region? See Stump Grinding & Stump Removal.

Need stump grinding in Hubbard?

Free written estimate, usually within a couple of business days. Licensed, insured, and we clean up completely.

(817) 508-9940

Request a free estimate

Monday–Friday, 8:00 AM – 5:00 PM · Storm and hazard calls are answered outside office hours.

Call (817) 508-9940