Licensed & insured Certified Arborist on staff Serving DFW since 2014

Land Clearing & Lot Clearing in Grandview, Texas

Clearing brush, scrub and trees off building pads, pasture and fence lines. Serving Grandview and the rest of Johnson County since 2014 — free written estimates, fully insured crews, and complete clean-up.

Call (817) 508-9940 Get a free estimate

Do you provide land clearing in Grandview, TX?

Yes — we do land clearing throughout Grandview, TX. Clearing brush, scrub and trees off building pads, pasture and fence lines. Most jobs run $1,500–$6,000 per acre. We are a licensed, insured Johnson County tree service with a Certified Arborist on staff, and estimates cost nothing.

Grandview is a small Johnson County town of roughly 1,879 — bigger lots, older trees, and fewer crews willing to drive out. Clearing is measured in acres and access, not in trees. What it costs comes down to stem density, terrain, how much has to leave the property, and whether you want the root mat out or just the top growth off.

Clearing near Grandview means dealing with honey mesquite and cedar elm on shallow alkaline clay over limestone. Stem density and how wet the ground stays decide the price far more than the acreage figure does.

Service
Land Clearing
Area
GrandviewJohnson County
Typical range
$1,500–$6,000per acre
Estimates
Freewritten, no obligation

What is included in Grandview

  • Building pad and homesite clearing
  • Pasture reclamation and cedar removal
  • Fence-line and right-of-way clearing
  • Underbrush mulching and forestry mowing
  • Selective clearing that keeps the trees worth keeping

What land clearing costs comes down to

Clearing is priced by acre, but the acre is the least useful number. What actually drives the cost is stem density (scattered mesquite versus solid cedar), terrain and slope, how much material has to leave the property rather than be mulched in place, and whether you need the root mat out or just the top growth off.

Mulching in place with a forestry cutter is by a wide margin the cheapest finish and leaves a mulch layer that suppresses regrowth and holds soil. Grubbing roots out and hauling everything off costs several times more, and is only worth it when something is going to be built on the ground.

Do not clear-cut what you will want back

The most common regret we hear is clearing a lot flat and then paying to replant shade fifteen years later. Selective clearing — taking the scrub and the junk stems, keeping the specimen trees and the ones shading the future homesite — costs a little more per acre and is worth far more. We will walk it with you and flag what is worth keeping before anything starts.

How the job runs

Land Clearing in Grandview, step by step

  1. Walk and mark the boundary

    Property pins, easements and keep trees flagged before any machine moves.

  2. Agree the finish

    Mulched in place, chipped and hauled, or grubbed to bare dirt — three very different prices.

  3. Clear in phases

    Underbrush first so we can see the stems worth keeping, then the selected removals.

  4. Handle the material

    Mulch spread, burned where legal and permitted, or loaded and hauled to a licensed site.

  5. Final grade and walk

    Ground left workable, stumps handled to the agreed depth, and a walk-through before the equipment leaves.

Pricing

What land clearing costs in Grandview

Most land clearing work in Grandview falls between $1,500 and $6,000 per acre. That is a real range, not a teaser — what puts a job at one end or the other is below.

What moves the price

  • Acreage, and how much of it is genuinely wooded
  • Stem density and average diameter — dense cedar is the expensive case
  • Terrain, slope and how wet the ground stays
  • Whether material is mulched in place or hauled off
  • Stump handling: leave, grind, or grub out entirely

The only way to get a real number is for someone to look at it. That visit is free — request an estimate or call (817) 508-9940. Full pricing detail for every service is in our North Texas tree service cost guide.

Local conditions

Grandview soil, species and timing

The fort worth prairie runs under Grandview: thin, rocky alkaline clay over limestone bedrock. Mature canopy here is mostly live oak and cedar elm, with Shumard oak where there is more depth. Root plates here are wide and shallow because there is nowhere to go down — limestone is often less than two feet under the grass.

We cover ZIP code 76050. Grandview sits inside a tight cluster of towns we run every week: Itasca (8 mi), Covington (8 mi), Coyote Flats (9 mi) and Alvarado (9 mi) are all on the same route.

People in Grandview search for this as forestry mulching, acreage clearing, or simply brush clearing in Grandview — it is all the same job, and the estimate is free either way.

FAQ

Land Clearing in Grandview — questions we get asked

How much does land clearing cost per acre near Grandview?

For light underbrush and scattered trees, budget roughly $1,500–$3,000 per acre mulched in place. Dense cedar or heavy timber with haul-off runs $4,000–$6,000+ per acre. Steep, wet or hard-to-access ground pushes it higher. We quote per job after walking it, because per-acre averages are close to meaningless until someone has seen the stems.

Do I need a permit to clear land in Johnson County?

Outside city limits in Johnson County, clearing your own agricultural or residential acreage generally does not require a permit, though burn bans and county burn permits apply to disposal. Inside city limits, or on platted land, tree ordinances and land-disturbance rules often do apply. We check before we start.

Do you offer discounts for multiple trees?

Effectively yes — the second tree on the same visit costs less than it would on its own because setup, travel and haul-off are already covered. If you have several trees needing attention, get them all quoted at once rather than one at a time.

Do you give free estimates in Grandview?

Yes. Someone comes out, looks at the tree, and you get a written price with the scope spelled out — no charge and no obligation. We do not quote tree work over the phone from a description, because the things that change the price (access, what is underneath, how the wood has to come out) are not visible from a description.

Do you clean up afterwards?

Completely. Brush chipped and hauled, wood removed or stacked as you prefer, ground raked and blown off. We walk the site with you before we leave. Clean-up is included in the quoted price — it is not a line item that appears later.

Can you work around my schedule?

Usually. Most residential work happens on weekdays during business hours, but we can often arrange early starts or a specific day if access, pets or gates require it. Commercial properties routinely get after-hours or weekend scheduling.

Do you serve areas outside Grandview?

Yes — our regular territory covers Tarrant, Johnson, Parker, Hill and Bosque Counties and the cities inside them. Grandview is on our normal route.

How soon can you get to my property in Grandview?

Estimates in Grandview are usually within a couple of business days. Scheduled work typically runs one to two weeks out depending on season — spring and post-storm periods are busiest. Hazard situations get moved to the front of the queue.

Land Clearing near Grandview

We cover the whole corridor, so a job in Grandview is rarely a special trip.

See all cities in Johnson County, or our full service area map. Looking for land clearing across the whole region? See Land Clearing & Lot Clearing.

Need land clearing in Grandview?

Free written estimate, usually within a couple of business days. Licensed, insured, and we clean up completely.

(817) 508-9940

Request a free estimate

Monday–Friday, 8:00 AM – 5:00 PM · Storm and hazard calls are answered outside office hours.

Call (817) 508-9940